The enclosure can also be powered by 220 V current, via a DUAL Lacme 1A 220 volt power supply (optional).
For the assembly of this fence you can follow the guide for the assembly of the complete Electric Fence for wild boars
Fence Installation Guide
Fix the 2 wooden poles of the entrance to the ground, with the relative ISOBAR insulators present in the package of the barrier kit 665902 (3 per pole, at a height of 25 cm, 50 cm and 90 cm from the ground).
Then install a cm pole every 5 meters. There are 90 poles in the package.
Install the signal boards for electric fences, and the three fence entrance barriers.
Install the solar panel Lacme 626104 on the energizer in the appropriate housing, with the bracket provided, following the instructions that are in the package. Insert the 5422 - Rechargeable Battery battery inside the Lacme
613000 energizer and connect the 2 obligatory plugs (positive and negative, with different sizes). Close the energizer (which does not necessarily have to be placed indoors), connect the ground wire to the machine and place the ground poles (included in the energizer package) in the ground, which must remain moist (water if necessary). Install the Inter Galva connections to ensure that the current spreads over all three rows.
Finally, test the system with the special Lacme voltage tester supplied. To do this, you need to insert the tester probe into the ground and let the wire of the fence touch the metal part located at the top of the tester. The LEDs must all be turned on, otherwise there is a power failure that must be identified and fixed.
For any changes to this package you can contact us via this page.
If you have a question, please use the form at the bottom of the page.
